Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Sliding glass doors
Impact garage doorsPGTCGI
Before
After
Before
After
Before
AfterFast, Reliable Window Installation Across Lake Park
Window installation in Lake Park has to account for one hard fact: this town sits entirely inside Palm Beach County’s wind-borne debris region, and the salt air off the Lake Worth Lagoon corrodes standard aluminum frames faster than nearly anywhere else in the county. That combination means most of the 1940s-1960s concrete block homes here are running original jalousie or single-pane aluminum windows that fail code the moment a permit gets pulled. TruePane Windows & Doors installs impact-rated windows built for exactly these conditions, and we do it with a live person answering the phone at (850) 801-5596 whenever you call. Our Window Installation crews know the older CBS construction along Park Avenue and throughout the Kelsey City blocks, because we work them every week.
Why TruePane Windows & Doors Is Lake Park’s Preferred Window Installation Company
Dale Kessler founded TruePane in 2008, but the craft behind it traces back years of glazing work. That matters in Lake Park because the window openings here are not standard tract-home sizes. The post-WWII concrete block homes that dominate nearly every residential street were built by hand, one course of block at a time, and the rough openings often run a half-inch or more out of square. A crew that only knows modern stucco tract construction will fight an opening like that all day and still leave gaps. Our technicians measure every opening twice, quote manufacturer lines side by side on paper, and register both warranty layers before the truck leaves the driveway. That is The Keystone Standard, and it applies to every job we run in Lake Park.
We also know what the local inspectors look for. When a homeowner near Lake Shore Drive opens a permit for anything structural, the wind-borne debris requirement triggers even if they only planned to replace one window. We have seen homeowners get caught by that, and we make sure it never happens to ours. The Done Right Promise backs the work: if it is not right, we make it right. No paperwork, no arguing. That promise is why Lake Park homeowners who have been burned by contractors before tend to call us first, and then keep our number.
We are part of this community. TruePane sponsors county fairs and church roof funds because we plan to be here in thirty years. A live person answers our phone 24 hours a day, 7 days a week. Not a voicemail tree. Not a call center. When you call about window installation in Lake Park, you get a person who can actually help you.
Our Window Installation Services in Lake Park
Different houses in Lake Park need different windows, and the salt-air exposure off the Intracoastal means the wrong frame material will fail within a few seasons. Here are the four most common installations we do in this town, and why each one fits the local housing stock.
Casement Windows
Casement windows are the most common upgrade we install in Lake Park’s older CBS homes. The crank-operated sash seals tight against the frame on all four sides, which matters when a squall off the Lagoon drives rain sideways into a window. For homes near the water, we recommend casements with marine-grade fusion-welded frames and impact-rated laminated glass. A standard casement replacement in Lake Park typically runs $600-$1,200 per opening depending on size and impact rating, and custom-order units for non-standard 1950s openings usually add 10-15% to the base window price.
Fixed & Picture Windows
Original jalousie windows in Lake Park often sat next to fixed picture windows, and those picture units are usually single-pane float glass with aluminum frames pitted from forty years of salt exposure. Replacing a fixed or picture window with an impact-rated insulated glass unit does more than satisfy the wind-borne debris code, it cuts the radiant heat load in a concrete block house that soaks up South Florida sun all afternoon. A fixed impact-rated picture window in Lake Park generally runs $450-$1,100 depending on the rough opening size and whether the frame needs marine-grade treatment.
Sliding Windows
Sliding windows are common on the 1960s sections of Lake Park, particularly in the ranch-style homes west of US-1. The issue we see most is corroded roller tracks, a direct result of salt spray settling into the aluminum channels and breaking down the anodized finish. When we replace sliders in Lake Park, we use stainless or marine-grade hardware and specify interlocks rated for the FBC wind load for this location. A standard two-lite impact-rated sliding window here typically runs $500-$1,100.
Single & Double Hung Windows
Many Lake Park homes have double hung windows that were installed as replacements in the 1980s and 1990s, before Florida’s wind-borne debris codes tightened to the current standard. Those windows are often in decent mechanical condition but fail any compliance inspection because the glass is not impact-rated. We remove and replace them with modern single or double hung impact units that keep the look of the original opening while meeting the current code. A replacement single hung in Lake Park runs about $500-$950, and a double hung runs $650-$1,250, with custom sizes at the higher end.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Lake Park
TruePane is an authorized installer for more than a dozen manufacturer lines, and for Lake Park specifically we steer most homeowners toward PGT, CGI, and Ply Gem. These three manufacturers produce impact-rated products with track records in South Florida’s wind-borne debris region and salt-air conditions, and we can quote them side by side on paper so you see exactly what you are buying. We stock a range of components for these lines, which means shorter lead times for Lake Park customers compared to shops ordering everything from out of state. If you want to know what the difference is between a PGT 550 series and a CGI Sentinel, we will tell you straight, including the price difference.
Common Window Installation Problems We See in Lake Park Homes
- Non-compliant jalousie windows still in place since 2004. Many owners kept their original jalousie louvers after the 2004 hurricane season because the frames were still intact. But those louvers offer zero missile impact resistance. The moment a permit opens for any work, the inspector flags them, and the job expands to full impact-window replacement whether the homeowner planned for it or not.
- Salt-air corrosion on non-marine-grade aluminum frames. This is the most common failure mode on homes east of Federal Highway within walking distance of the Lagoon. The frames pit at the jamb and the sill within two to three years. The seals fail, the insulated glass units fog, and the window is done. We specify marine-grade finishes on every coastal Lake Park job.
- Rough-opening modification botched on older CBS walls. Concrete block walls from the 1950s shift and settle, and the original openings are rarely square. If a crew sets a window into an out-of-square opening without shimming and flashing it correctly, gaps form between the buck and the block. Water gets in, and over time the interior drywall shows stains while the frame starts to move. This is avoidable, but only if the installer actually cares to do it right.
- Contractors skipping the wind-borne debris permit. A cheap quote that omits the permit usually also omits the impact rating. The homeowner discovers the problem later, often during an insurance inspection or a re-roof that triggers a code review. Now they are paying for windows twice, and the original contractor is long gone. Permit and code compliance is not optional in Lake Park, and it should be in the written quote.
Pricing for Window Installation in Lake Park, FL
For a typical 1,200-1,600 square foot CBS home in Lake Park, replacing all windows with impact-rated units generally runs $12,000-$24,000 depending on the number of openings, sizes, and whether the frames require custom fabrication for non-standard rough openings. A single standard impact window in this market falls in the $500-$1,200 range installed, with casements and pictures at the lower end and larger sliders or custom units at the higher end. Marine-grade frame upgrades for homes near the Lagoon typically add 8-12%. Every quote we write for Lake Park includes the wind-borne debris permit fees, the rough-opening flashing work, and the post-installation inspection steps, because leaving them out is how a low bid becomes an expensive surprise. Call (850) 801-5596 for a written, line-item quote. Estimates are free, and the price we quote is the price on the bill.
We Also Serve Cities Near Lake Park
TruePane crews serve Lake Park and the surrounding communities, including Palm Beach, Lake Worth Beach, Westgate, and Palm Springs. If you live near the Lake Worth Lagoon or in the developments along Northlake Boulevard, you are still in our service area. Call (850) 801-5596 and we will let you know when we can be there.
Serving Lake Park, FL - Our Local Coverage Area
We’re based in the Lake Park area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Window Installation in Lake Park
The proof comes in three parts: the product approval documentation showing the window meets FBC impact requirements, the permit filed with Lake Park’s building department before the work starts, and the final inspection that closes the permit out. TruePane registers both manufacturer warranty layers in writing and provides the product approval paperwork for every window we install. We do not leave a job until the inspection passes and the permit is closed, because that paperwork is what protects you later when you renew your insurance or sell the house. Call (850) 801-5596 to get a quote that includes full documentation.
We schedule Lake Park jobs throughout the week, and for a standard window installation, we can typically begin within a week to ten days of accepting the quote. Custom-order impact windows for non-standard 1950s openings add lead time, usually three to five weeks depending on the manufacturer. When a storm is approaching, we prioritize existing customers and emergency board-up calls in Lake Park first. A live person answers the phone at (850) 801-5596, 24 hours a day, so you will always know where you stand.
We cover all of Lake Park, which is compact at roughly 1.5 square miles, meaning most homes sit within a short drive of Park Avenue, Kelsey Park, Lake Shore Drive, and the blocks between US-1 and the Intracoastal. We work the older CBS streets near the Lagoon, the ranch homes west of Federal Highway, and everything in between.
Our window installation pricing is based on the job, not the ZIP code, but Lake Park’s older CBS construction means many homes require custom-ordered impact units for non-standard openings, and that does add cost compared to a newer tract home in Westgate or Palm Springs. Salt-air exposure near the Lagoon may also justify marine-grade frame upgrades that add roughly 8-12% to the window cost. What we never do is pad a quote because the address is on the water. Call (850) 801-5596 for an exact figure.
You get two manufacturer warranty layers registered in writing, with durations stated, plus our Done Right Promise. If something on our installation is not right within 90 days, we make it right, no paperwork and no arguing. The manufacturer warranties cover the window product itself, and the registration happens before our truck leaves your driveway, so there is no gap in coverage. That is The Keystone Standard, and it applies to every window we install in Lake Park.
If you are ready to replace the original jalousies or the salt-pitted aluminum frames on your Lake Park home, call TruePane Windows & Doors at (850) 801-5596. We will measure, we will quote, and we will do the job right. Free estimates, written line-item pricing, and a person who answers the phone.
Written by Dale Kessler, Owner at TruePane Windows & Doors, serving Lake Park with years of glazing craft.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.