Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Mr-Glass Roof Repair in Palm Beach: What to Know First
Mr-Glass roof repair in Palm Beach is work we take on as an independent service provider, not as a factory-authorized dealer. Most Mr-Glass roof glass and skylight repairs run $450 to $1,400 depending on the series and whether the frame was set correctly the first time, and we typically complete the job in a single visit once parts are in hand. If you own a Mr-Glass roof unit in Palm Beach and it is leaking, fogged, or showing stress cracks, this page will tell you what is actually going on and what it takes to fix it right. Call (850) 801-5596 and a live person will answer, day or night.
How Mr-Glass Products Fail - and How We Fix Them
After years of opening up Mr-Glass roof units in Palm Beach, we have learned where these systems give out. The failures are rarely mysterious, but they are often misdiagnosed by contractors who treat every roof skylight the same. Here is what we find.
- Flange seal breakdown on the residential curb-mount line. The Mr-Glass curb-mount units common in older Palm Beach ranch homes were set with a butyl tape that dries out after eight to ten Florida summers. The glass itself is fine, but water gets between the flange and the curb and runs inside the chase. We pull the unit, clean the curb face back to wood, apply new sealant at the correct depth, and reseat the frame so water has no place to pool.
- Stress cracks at the corner of the Mr-Glass sloped units. Palm Beach roofs settle, especially the older barrel-tile and flat-deck homes east of Olive. A Mr-Glass roof panel that was shimmed too tight at one corner will crack there first, every time. We see this on the sloped series regularly. The fix is never just swapping the pane; the frame has to be released, repositioned, and reseated so the stress stops at the frame, not at the glass.
- Weep-channel clogging on the sliding roof vents. The Mr-Glass operable roof vents need their weep channels to breathe, and Palm Beach delivers enough wind-driven rain and leaf debris to clog them within a season. The symptom is a slow drip inside after a hard storm. We clear the channels, verify they drain, and adjust the track so the vent seats flush when closed. It takes an hour, not a new unit.
- Fogging between panes on the Mr-Glass insulated roof assemblies. When the edge seal on an insulated Mr-Glass roof unit goes, the glass fogs and no cleaning will fix it. In Palm Beach humidity, a failed seal also invites condensation that drips onto drywall. We replace the insulated glass unit and register the new IGU warranty in writing before the truck leaves your driveway. That is the Keystone Standard, and we do it on every job that carries a manufacturer warranty.
- Flashing failure around the Mr-Glass curb perimeter. On many Palm Beach roofs, the original flashing was step-flashed with galvanized metal that has since corroded in the salt air west of the Intracoastal. The lead or aluminum flashing fails before the skylight does. We replace the flashing, re-bed the curb, and test the assembly with a hose before we pack up. If the flashing is not right, the best skylight in the world will still leak.
Our Mr-Glass Roof Repair Process
Every Mr-Glass job follows the same sequence, and nothing gets skipped because it is Friday afternoon or the roof is hot.
- 1
We come out and assess. A technician inspects the roof unit, the flashing, the curb, and the interior water path. We measure twice, and we take photos of everything we find.
- 2
We give you a written line-item quote. No verbal ballparks. You see the parts, the labor, and the exact price before any work begins. If something is salvageable, we tell you; we do not pad a job with parts you do not need.
- 3
We make the parts call together. For Mr-Glass units, we discuss OEM versus quality aftermarket parts on paper, including lead times and warranty implications. You decide with the facts in front of you.
- 4
We do the repair. The old glass and sealant come out clean, the frame gets inspected and corrected if it is out of square, and the new assembly goes in with sealant depth measured and documented.
- 5
We test it. We water-test the repaired area and check the interior for any sign of dampness. The job is not done until the pane is true and the water stays outside.
- 6
We register both warranty layers in writing. Before we leave, you have the manufacturer warranty and our Done Right Promise in hand. If it is not done right, we make it right. No paperwork fights, no arguing.
What Mr-Glass Roof Repair Costs in Palm Beach
The price depends on what failed and which Mr-Glass series you have. Replacing a single roof glass pane with standard clear glass starts around $450 on a small curb-mount unit. A full insulated glass unit replacement for a fogged Mr-Glass assembly runs $800 to $1,200, more if the frame needs to be reset or the flashing replaced. Full unit swaps including new curb flashing land between $1,200 and $2,600, and if the roof deck is rotten beneath the curb, carpentry costs get added on in writing before we touch it.
What moves the price: the size of the opening, whether the unit is operable or fixed, access to the roof, and whether we are matching an existing tint or low-E coating. We give you a fixed price up front, not an estimate with a handshake. Call (850) 801-5596 and we will schedule a free assessment and put the numbers on paper.
Why Palm Beach Homeowners Call TruePane Windows & Doors for Mr-Glass Work
We know Mr-Glass roof units because we have repaired enough of them to know what fails and why. But the bigger reason Palm Beach homeowners call us is the company we run while we do it. We are an authorized installer for PGT, CGI, CWS, and ES Windows, and we carry more than a dozen manufacturer lines, so when a Mr-Glass unit is beyond repair we can quote you side-by-side replacements on paper, not with a shrug. One of our background-checked, uniformed technicians shows up when we say, measures everything twice, and leaves your home the way he would leave his own mother’s. We have been doing this work since 2008, and we plan to be in this town in thirty more.
FAQs
Can you still repair a Mr-Glass roof unit if the warranty has expired? Yes. As an independent Mr-Glass service provider, we repair out-of-warranty units every month in Palm Beach. We will match parts that are still being made and recommend the most sensible aftermarket option when an OEM part is discontinued. Call (850) 801-5596 for a free assessment.
How long do Mr-Glass roof repairs take? Most repairs are completed in one visit once parts are in hand, and the physical work usually takes two to four hours depending on access and the extent of flashing damage. If roof carpentry is needed, we will put that in the quote up front so there are no surprise days added later.
Is a fogged Mr-Glass roof unit always a replacement job? If the fog is between the panes on an insulated unit, the edge seal has failed and the glass assembly must be replaced. Surface condensation from humidity is different and may not require new glass at all. We will tell you which one you have, and we will not sell you a new unit you do not need.
Should I repair my Mr-Glass roof skylight or replace it? If the frame and curb are sound, a repair almost always costs less. If the frame is corroded, the flashing is gone, or the unit is decades old, replacement with a PGT or CGI product may be the smarter money, and we will quote both options on paper so you can see the difference. Call (850) 801-5596 for the numbers in writing.
Will the price change once the work starts? No. We quote a fixed price and we stick to it. The only exception is if we open the roof and find hidden structural damage that no one could see from the outside, and if that happens we stop, show you the damage, and get your approval in writing before we go further. You will never get an invoice with a new line item and an apology.
Written by Dale Kessler, Owner, TruePane Windows & Doors at TruePane Windows & Doors, serving Palm Beach and nearby areas.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.



Before
After
Before
After
Before
After